Spod Source Bedienungsanleitung PDF herunterladen

sPOD Source Installation Instructions

www.4x4s-POD.com

1. Attach your accessories here.

SWx Is the Positive and GND is the negative terminals.

2. Negative battery terminal.

3. Positive battery terminal.

4. Switch panel harness input.

5. Low voltage detection circuit.

6. Low voltage detection circuit fuse. Remove this fuse to

disable LVCO

• If the LVCO detects a low voltage (10.6VDC) and

shuts the sPOD down, turn off all switches on sPOD

and start the vehicle to enable the sPOD again.

7. Accessory fuses. Any fuse can go here up to 30 AMPs. (6 pl.)

8. Relays that are removable.

Always keep your engine running

whenever possible when powering

electrical accessories

10 mm socket

12 mm socket

Auto Reset

Circuit Breaker

After installation

!!!Must start engine to activate system!!!

• Connect Positive & Ground wire to battery terminals. Use supplied cable ties to secure all cables.

Run white connector up

through opening in plastic

Plug connector in with

key facing outward

Seite 1

sPOD Source Installation Instructions www.4x4s-POD.com 1 1. Attach your accessories here. SWx Is the Positive and GND is the negative terminals.

Keine Kommentare

Spod Source Bedienungsanleitung